This manual demonstrates step by step procedures involved in modeling, analysis and design of typical reinforced concrete row houses in the famous structural engineering software CSI ETABS. Contents of the manual are as mentioned below,
- Objectives
- Problem
- Step by Step
1. Start Model with Template
2. Define Material Properties
3. Define and Assign Beams Sections
4. Define and Assign Column Sections
5. Define and Assign Slab Section Properties
6. Add Stairs to Model
7. Assign Load on Beam~ and Slab Panels
8. Define Load Cases and Load Combination
9. Replicate Model
10. Specify Meshing Option for Shell Element (Slab Panels)
11. Draw Dummy Walls and Assign Wind Load
12. Assign Spring Support
13. Run Analysis
14. View Analysis Results
15. Start RC Design
3. Define and Assign Beams Sections
4. Define and Assign Column Sections
5. Define and Assign Slab Section Properties
6. Add Stairs to Model
7. Assign Load on Beam~ and Slab Panels
8. Define Load Cases and Load Combination
9. Replicate Model
10. Specify Meshing Option for Shell Element (Slab Panels)
11. Draw Dummy Walls and Assign Wind Load
12. Assign Spring Support
13. Run Analysis
14. View Analysis Results
15. Start RC Design
This manual has been developed by ACECOMS Asian Institute of Technology(AIT), Thailand. It can be downloaded from link below. Professional engineers, students and other professionals are encouraged to share similar helpful manuals/tutorials for common good.